For the prototyping of a new product, due to structural constraints, a T-slot cutter was required to machine the internal bottom surface. The design specified a transition radius of R1.5 between the b...
I would like to know, for the transparent SLA resin 3d prints, is there any shrinkage? When I did these prints on my Elegoo Saturn 3 with Anycubic clear resin I encountered enough shrinkage that I had...
It is said that soft materials such as Q235-A, 08F, etc. cannot be ground. To use hard materials, such as 42CRrMo,40Cr, etc., after quenching can be ground. May I ask why?
2mm thick cold-rolled 304 stainless steel plate (raw material), placed outdoors in the sun and rain, will it rust for a long time? If there is rust, how long will it take to develop extensive rust spo...
A shaft tooth, after machining, does not pass the dynamic balance test.Now I would like to ask how the dynamic balance of the part can be controlled in the machining process.The whole of the part to t...
