This design came out perfectly. Thank you very much!!
This part was a prototype bracket with a topology optimized design for optimum stiffness to weight given critical stresses and mass target, printed by Justway in 316L Stainless Steel. The parts came ...
Print is good, there are no warps and no defects visible.
This is a prototype of a solid state anemometer. Designed with FreeCAD and fabricated with Justway. It is perfect! In particular the channels are perfectly opened (they are 1mm of diameter only!) .
All features are within 0.4mm of spec. Arrived slightly wrapped. Due to a design error, the well in the center is too shallow for the 35mm Petri dish to sit in.
we are trying to to wrap a wire around a tube but was having problems with the even spacing between wraps. this #D printed part working great! made wrapping a lot easier!
As always Justway confirms the quality of its services. Great work!
Very satisfied with the outcome! The distortion is minimal. Small features are very well reproduced. The mating surfaces function flawlessly. The module 1.0 helical gears mesh smoothly. One minor iss...
Case for my FM radio
The tenon is about 0.3mm too narrow, resulting a poor fit over the holding ring. The bottom of the tenon fall off the mortise on the holding ring for about 1.6mm. The cut out on the other end for the ...
отлично получилось, минимальная обработка до товарного вида, настоящая нержавейка, прочность сомнений не вызывает
Display bezel made from UTR8220 Resin, with inserts. I'm highly satisfyed with the quality and a bit surprised, how stiff that material is. I painted it black with Acrylic paint.
This came out wrong. Print came out 30.9cm long, when it should have been 30cm exactly. I'm guessing this is the designer's fault and not PCB Way considering the other prints on my order came out perf...
Good
Parts were functionally and aesthetically perfect. Delivery was on time.
In essence the outcome is good. But the unit is warped from one corner to the diagonal. See attachment. The lower right corner of the unit is not touching the surface and so as the diagonal corner ...
1 2 3 4 5 6 7 8 9 10 11 ...